Set Up, Installation And Connection; Connecting The Pump - KNF Laboport N96 Manual De Instrucciones

Set up, installation and connection

Cooling air
supply
Installation
location
Vacuum
operation
Pressure
operation
20
8 Set up, installation and connection
Only connect the pumps in accordance with the operating pa-
rameters and conditions described in Chapter 5 Technical
data.
Observe the safety notices (see Chapter Safety).
à
Before connecting, store the pump at the installation loca-
tion to allow it to reach the room temperature (no conden-
sation may form).
WARNING
à
Make sure that the installation location is dry and that the
pump is protected against rain, splash, gushing, and drip
water as well as from other contaminants.
à
Select a secure location (flat surface) for the pump.
à
Protect the pump from dust.
à
Protect the pump from vibration, impact and external dam-
age.

8.1 Connecting the pump

1. Remove the protective plugs from the pneumatic connec-
tions of the pump.
2. Mount suction filter or silencer accessory parts (if
present).
For vacuum operation, connect the hose connector (see Fig.
2/5) to the suction side and the silencer (see Fig. 2/4) or your
system components to the pressure side.
For pressure operation, connect the hose connector to the
pressure side and the silencer or your system components to
the suction side.
Translation of Original Operating Instruction, english, KNF
Laboratory pump Laboport® N96
Danger of burning on hot surfaces
Hot surfaces could occur if the pump
overheats.
à
When installing the pump, make
sure that sufficient cooling air in-
feed and discharge is ensured.
323241-323242 06/20