therm-ic POWERGLOVES Manual Del Usario página 22

Turning the device ON:
Press and hold down the function button (1.2) (for
approx. 3 seconds) to set the Therm-ic PowerGloves
to the lowest heating level. If the button is pressed
for more than 6 seconds, the gloves will go into
safety mode and switch off.
Changing the heat setting:
Pressing the function button once (for approx.
1 second) will increase the heating setting (level 1,
level 2 or level 3).
• Level 1: 1 flash, low heating setting.
• Level 2: 2 flashes, medium heating setting.
• Level 3: constant light, high heating setting.
Turning the device OFF:
To switch off the Therm-ic PowerGloves, press and
hold the function button (1.2) (for 3 seconds, until the
heating level indicator light switches off).
IMPORTANT INSTRUCTIONS FOR USE
• Charge the batteries before each use.
• When switching on the Therm-ic PowerGloves, do
not leave them set to level 3 for more than a few
minutes; continuous use at this setting risks raising
the temperature excessively and may cause burns.
• Always set the Therm-ic PowerGloves to the
level 1 or level 2 setting to keep your fingers at
a comfortable temperature (the warming effect
should be practically imperceptible).
• The optimum heating temperature is reached when
the gloves are dry.
HEATING SETTINGS
Level
1
2
3
Measurements made under laboratory conditions
directly on the heating element. The heating duration
per charge depends on the heating level selected, the
ambient temperature, the age of the batteries and
their charge level.
Heating duration per charge
8-10 hours
4-5 hours
2-2,5 hours