Machine Components; Machine Assembly - Tennant 2120 Manual Del Operario Y Lista De Piezas

6. When transporting machine:
- - Get assistance when lifting machine.
- - Unplug cord from wall outlet.
- - Use tie- -down straps to secure machine to
truck or trailer.
GROUNDING INSTRUCTIONS
Machine must be grounded. If it should
malfunction or breakdown, grounding provides a
path of least resistance for electrical current to
reduce the risk of electrical shock. This machine
is equipped with a cord having an
equipment- -grounding conductor and grounding
plug. The plug must be plugged into an
appropriate outlet that is properly installed in
accordance with all local codes and ordinances.

MACHINE COMPONENTS

3
4
5
6
7
8
13
11
1. Control Handle
2. Handle Height Adjustment lever
3. Safety Lock Lever
4. On/Off Lever
5. Solution Control Lever for Optional Solution Tank
Tennant 2120/2140 (01- -2006)
1
4
2
10
9
12
Home Find... Go To..
6. Power Cord
7. Power Cord Storing Hook
8. Transport Wheels
9. Motor
10. Component Housing
11. Scrub Head Base
12. Bumper
13. Solution Supply Connector for Optional Solution
Tank

MACHINE ASSEMBLY

Carefully check carton for signs of damage. Report
damages at once to carrier.
ATTACHING HANDLE TO BASE
1. Position the handle assembly on the base as
shown. Insert (4) screws, supplied, through the top
of the handle support and into the machine base.
From bottom side of base, secure screws with
nuts and washers, 13 mm wrench required
(Figure 1).
2. Connect the power cord into the switch housing
receptacle (Figure 1).
ATTACHING OPTIONAL SOLUTION TANK
1. Attach the upper solution tank support bracket to
the handle as shown, do not tighten screws at this
time, 5mm allen wrench required (Figure 2).
2. Insert the tab at the bottom of the solution tank
into the tank support slot located near the handle
base as shown. Secure the top of the tank with
the upper support bracket as shown. Then tighten
the upper support bracket screws (Figure 3).
3. Connect the chain to the solution control lever.
Connect the solution feed tube to the solution
supply connector on the machine base (Figure 4).
WARNING: Do Not Use Flammable Liquids Or
Operate Machine In Or Near Flammable Liquids,
Vapors Or Combustible Dusts.
This machine is not equipped with an explosion
proof motor. The electric motor will spark upon
start up and during operation which could cause a
flash fire or explosion if machine is used in an
area where flammable vapors/liquids or
combustible dusts are present.
FOR SAFETY: When using machine, follow mixing
and handling instructions on chemical containers.
OPERATION EN
5