Inserting/Removing The Battery Pack; Checking The Battery Charge Level; Additional Handle; Depth Stop - Parkside Performance PSBSAP 20-Li A1 Traducción Del Manual De Instrucciones Original

Inserting/removing the battery pack

Inserting the battery pack
♦ Set the rotation direction switch
position (lock). Push the battery pack
the handle until it clicks into place.
Removing the battery pack
♦ Press the release button
battery pack .

Checking the battery charge level

♦ Press the battery charge level button
check the status of the battery (see the main
diagram). The status/remaining charge will be
shown on the battery display LED
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery

Additional handle

NOTE
► For safety reasons, you should never use
this tool without the additional handle
attached.
♦ Loosen the strap on the additional handle
by turning it clockwise.
♦ Slide the mounting ring for the additional
handle over the chuck .
♦ Turn the additional handle
position.
♦ Afterwards, twist the additional handle
anticlockwise again to tighten it.
PSBSAP 20-Li A1
to the middle
into
and remove the
to
as follows:
to the required

Depth stop

♦ Push the locking button for the depth stop
and keep it pushed in.
♦ Fit the depth stop
handle .
♦ Make sure that the teeth on the depth stop
point upwards and downwards.
♦ Pull the depth stop
between the tip of the drill and the tip of the
depth stop corresponds with the required
drilling depth.
♦ Release the locking button for the depth stop
to lock the depth stop

Changing tools

Your cordless impact drill driver has a fully auto-
matic spindle lock
When the motor is stopped, the power train is
locked so that the chuck
turning . After you have attached the desired
tool and tightened it by turning the chuck
can continue working. The spindle lock is released
automatically when the motor is started (by pressing
the ON/OFF switch ).
Torque selection/selecting the
operating mode
You can set the torque using the torque selection
ring or by choosing between the drill setting
and the hammer drill setting
♦ Select a low level for small screws or soft
materials.
♦ Select a high level for large screws, hard
materials or removing screws.
♦ Select the drill setting for drilling work by adjusting
the torque selection ring to the position .
♦ Select the hammer drill setting for hammer drilling
work by adjusting the torque selection ring to
the position .
into the additional
out until the distance
in place.
.
can be opened by
, you
.
GB │ MT │
57 ■