Human Touch GRAVIS ZG CHAIR Manual De Instrucciones página 5

4
INSTALL THE HEAD PILLOW
Place the head pillow into position then thread the straps
through the retaining strap on the back of the headrest.
Retaining strap
5
INSTALL THE ARMRESTS AND REMOTE POCKET
1. The armrests are labeled L (left) or R (right), as you're sitting in the chair. Be sure to install each armrest on
the correct side of the chair, with the angled end of the armrest toward the back. Align the armrest as
shown below, with the armrest tabs positioned to the rear of the corresponding tabs on the chair arm.
Armrest tab
Chair tab
8
Head pillow
Head pillow straps
Armrest
Armrest tab
Chair tab
2. Turn the armrest over, lower it onto the chair arm, then slide it forward as far as it will go. Strike the back
of the arm firmly with your palm until locking mechanism clicks into place.
3. Repeat steps 1 and 2 to install the other armrest.
4. Pull up and backward on each armrest to make sure it is locked into place.
5. Attach the remote pocket metal strip to the magnets on the underside of the right-hand armrest.
Bottom of the right armrest
Rows of magnets
Metal strip
Remote pocket
9