Barnes QDX25-SS Serie Manual De Instalación Y Operación página 5

SECTION D - START UP OPERATION
DO NOT attempt to start a frozen pump.
Instead, submerge pump in water for twenty
minutes before starting. DO NOT attempt to
thaw a frozen pump with a torch.
Warranty Registration:
Fill in the Warranty Registration at the end of this manual
and send it in to our Warranty / Service Department. Also,
record the model number and date code numbers in
Section F-1 of this manual for future reference if needed.
SECTION E - PREVENTATIVE MAINTENANCE
The following procedure must be followed to assure
proper pump operation.
E-1) General Safety:
Frequent inspections shall be made. All electrical parts,
including the portable cable and wiring shall be kept in
a safe condition. KEEP CABLE GLAND NUT TIGHT.
CHECK FREQUENTLY. There shall be no openings in the
casing of the electrical parts. The operating voltage shall
match the voltage rating of the motor.
E-2) Cable Requirements:
Special care shall be taken in handling the cable against
mechanical injury and wear. Connections and wiring to the
power source shall be in accordance with all electrical and
safety codes.
HOME Manual Index
SECTION F - WARRANTY REPAIR
F-1) Information Needed: Always furnish the following
information:
1. Pump Model Number
2. Pump Date Code
NOTE: Record your pump information here for future
reference.
F-2) Model Number:
This designation consists of numbers and letters which
represents the horsepower, motor phase, voltage and
pump design.
F-3) Date Code:
The Date Code consists of two numbers that are punched
holes in the nameplate. This specifi es the month and year
indicating the date the unit was built.
Pumps sold as complete units only.
5
E
N
G
L
I
S
H