Tabla de contenido
Publicidad
CAUTION!
1.
If you adopt FSB400-CPU on this motherboard, you need to adjust the
jumpers. Please refer to page 11 for proper jumper settings.
2.
About the setting of "Hyper Threading Technology", please check page 26
of "User Manual" in the support CD.
3.
This motherboard supports Untied Overclocking Technology. Please read
"Untied Overclocking Technology" on page 16 for details.
4.
Please check the table below for the CPU FSB frequency and its corre-
sponding memory support frequency.
CPU FSB Frequency
800
533
400
5.
Due to the chipset limitation, the actual memory size may be less than
4GB for the reservation for system usage under Windows
Windows
®
Vista
TM
.
6.
The maximum shared memory size is defined by the chipset vendor and
is subject to change. Please check Intel
7.
For microphone input, this motherboard supports both stereo and mono
modes. For audio output, this motherboard supports 2-channel, 4-channel,
6-channel, and 8-channel modes. Please check the table on page 3 for
proper connection.
8.
Before installing SATAII hard disk to SATAII connector, please read the "SATAII
Hard Disk Setup Guide" on page 20 of "User Manual" in the support CD to
adjust your SATAII hard disk drive to SATAII mode. You can also connect SATA
hard disk to SATAII connector directly.
9.
Power Management for USB 2.0 works fine under Microsoft
TM
Vista
/ XP SP1 or SP2 / 2000 SP4.
10. ASRock Instant Flash is a BIOS flash utility embedded in Flash ROM.
This convenient BIOS update tool allows you to update system BIOS
without entering operating systems first like MS-DOS or Windows
this utility, you can press <F6> key during the POST or press <F2> key to
BIOS setup menu to access ASRock Instant Flash. Just launch this tool
and save the new BIOS file to your USB flash drive, floppy disk or hard
drive, then you can update your BIOS only in a few clicks without prepar-
ing an additional floppy diskette or other complicated flash utility. Please
be noted that the USB flash drive or hard drive must use FAT32/16/12 file
system.
11. Although this motherboard offers stepless control, it is not recommended
to perform over-clocking. Frequencies other than the recommended CPU
bus frequencies may cause the instability of the system or damage the
CPU.
12. While CPU overheat is detected, the system will automatically shutdown.
Before you resume the system, please check if the CPU fan on the
motherboard functions properly and unplug the power cord, then plug it
back again. To improve heat dissipation, remember to spray thermal
grease between the CPU and the heatsink when you install the PC system.
ASRock P4i945GC Motherboard
Memory Support Frequency
DDR2 400, DDR2 533, DDR2 667
DDR2 400, DDR2 533
DDR2 400
®
website for the latest information.
®
XP and
®
®
Windows
®
. With
7 7 7 7 7
Publicidad
Tabla de contenido
