Torque Adjustment - Yamato CD 12 L Manual De Instrucciones

5. TORQUE ADJUSTMENT

(Screw driving force of your drill driver)
The torque is adjusted by rotating the torque adjustment
ring. The torque is greater when the torque adjustment ring
is set on a higher setting. The torque is less when the torque
adjustment ring is set on a lower setting.
Make the setting as follows:
1 - 4 for driving small screws
5 - 7 for driving screws into soft material
8 - 10 for driving screws into soft and hard material
11 - 13 for driving screws into hard wood
14 - 16 for driving larger screws
" " for heavy drilling
6. USE THE SIGHT LIGHT
The sight light allows you to keep a clear view under less illuminated circumstances. To turn on the
light simply press the On/Off switch. When you release the On/Off switch, the light will be off.
7. SELECTING THE ACTION MODE (for drills with impact function)
Tools with impact function employ an action mode changing ring. Select one mode suitable for
your work. Turn the action mode changing ring and align the mark that you selected with the arrow
on the tool body.
Drilling mode without impact (rotating only)
Hammer drilling mode (rotating with hammering)
Screwdriving mode (rotating with clutch)
8. TRAPANATURA
When drilling hard smooth surfaces, use a center punch to mark the desired hole location. This will
prevent the drill bit from slipping off center as the hole is started. Hold the tool firmly and place the
tip of the bit at the point to be drilled. Depress the switch trigger to start the tool. Move the drill bit
into the work-piece, applying only enough pressure to keep the bit drilling. Do not force or apply
side pressure to elongate a hole.
Note: If your tool stop working when drilling a hole automatically, it's normal. This is the electrical
protection battery. Completely release the On/Off switch, the depress it to start the tool again.
1. Action mode changing ring
2. Adjusting ring
3. Graduation
4. Arrow
17