Starting + Stopping - sunjoe MJ-HVR12E Manual Del Operador

Fig. 3
4. Before assembling the upper handle frame, slide the
extension cord restraint holder on the upper handle frame
(Fig. 4).
5. Align the upper handle frame with the holes on the upper
end of the lower handle frame, and insert the handle frame
bolts into the holes from the inside (Fig. 4).
6. Secure the upper handle frame by tightening the upper
handle knobs on the ends of the upper handle bolts
(Fig. 4).
Fig. 4
Extension cord
restraint hook
Upper handle
frame
Lower handle
frame
7. Secure the cord by clipping it into the cable clips.
The hover blade grass cutter is ready for use.
Operation
This hover blade grass cutter is equipped with a powerful
10 A motor, which allows it to float on a cushion of air while
cutting the grass. The grass cutter is extremely lightweight and
easy to maneuver, and is ideal for irregularly shaped gardens.
Handle
Because of its unique design, the hover blade grass cutter
rotating knob
is good at cutting over flat paths, under bushes, down slight
slopes and around trees.

Starting + Stopping

Do not switch on the hover blade grass cutter until it has been
completely assembled. Before switching on the unit, always
check the appliance cord and the extension cord for signs of
damage. Use only intact cords.
m
WARNING!
Replace damaged cords immediately.
m
WARNING!
cutter, make sure that it is not in contact with any foreign
objects. Keep your hands and feet a safe distance away from
the rotating blades. Failure to comply with these warnings can
result in severe personal injury.
IMPORTANT: Do not start the grass cutter in tall grass.
1. Place the unit on a level lawn surface.
2. Push a loop of the extension cord through the slot on the
extension cord restraint holder from the opposite side and
around the cord restraint hook. Insert the appliance cord
into the extension cord (Fig. 5).
Fig. 5
Appliance
cord
Handle frame
knobs
Handle frame
bolts
NOTE: Do not plug the extension cord into the outlet until it
had been secured with the extension cord restraint holder and
connected to the hover mower's appliance cord. Only use a
UL-rated extension cord for outdoor, all-weather use. Do not
use an extension cord over 100 ft (30 m). See Extension Cord
Chart on page 2.
3. Place the bulk of the extension cord on the lawn closest to
the starting point.
8
Damaged cords pose a severe risk of injury.
Before switching on the hover blade grass
Extension
cord restraint
holder
Extension cord