Kohler K-527 Guia De Instalacion página 11

Troubleshooting (cont.)
Troubleshooting Table
Symptoms Probable Cause
4. Maximum A. Incorrect maximum
blend
temperature
too hot or too
cold.
B. If the above
5. Continuous A. System will not
flow.
Only cold A. Hot water supply
6.
water flows
from the
outlets.
B. Hot water inlet is
C. The hot water
D. If none of the
Kohler Co.
Recommended Action
A. Refer to the
"Temperature – Set
temperature
setting. the Maximum"
section in the Digital
Interface
Homeowners Guide.
B. Contact your Kohler
recommended Co. Authorized
action does not Service
correct the Representative.
symptom, the
interface or valve
requires servicing.
A. Turn off the water
switch off. and power supply
and contact your
Kohler Co.
Authorized Service
Representative.
A. Check if the hot
is either not turned water supply is
on or not turned on and
connected to the connected to the
valve inlet. valve inlet.
B. Check the hot water
blocked. inlet screen for
blockage. Clean or
replace the inlet
screen. Refer to the
Valve Homeowners
Guide.
C. Allow time for the
supply is water heater to come
exhausted. up to temperature.
D. Contact your Kohler
recommended Co. Authorized
actions for the Service
above issues Representative.
correct the
symptom, the
valve requires
servicing.
11 1143086-2-E