Complete The Installation - Kohler K-527 Guia De Instalacion

4. Complete the Installation

IMPORTANT! Make drip loops in all cables.
Press a split boot onto each interface cable.
Connect the interface cable to the valve. Ensure the cable fully
clicks into the valve socket.
Press the boot over the connector and into the valve socket to seal
the connection.
If only one interface is installed, insert a solid boot into the
unused socket.
5. Installation Checkout
Turn on the water supply to the valve.
Check all connections for leaks and make any adjustments as
needed.
Plug in the valve. You should hear the valve power up and the
power icon on the user interface will be lit.
If not already completed, refer to the "Digital Interface
Homeowners Guide" to set up the user interface.
NOTE: For more information about using the user interface and its
menus, refer to the "Digital Interface Homeowners Guide."
Press the power icon to turn on the shower.
Check for leaks and make any adjustments as needed.
1143086-2-E
Solid
Boot
Slide the split boot onto
the interface cable.
Split
Boot
8 Kohler Co.