Publicidad
Idiomas disponibles
Idiomas disponibles
Return Desk Assembly Instructions
Figure 6
Filler Block
#8 x 1/4" screw
Bottom Connector Plate
1-800-383-7414
#8 x 3/4" screws
Top Connector Plate
#8 x 3/4" screws
1.
With two or more people, turn the return desk upside
down. Place on cardboard or carpeted surface in
order to prevent the top from being scratched.
2.
Follow instructions 2-5 on previous page for leg
installation.
3.
Remove the top connector plate and filler block. See
Figure 6. Keep the top connector plate and screws
for the next step. The filler block can be discarded.
4.
Install the top connector plate on the 30" x 66" wide
single pedestal desk using 5 #8 x 3/4" screws.
5.
Use two or more people to turn the return desk
upright.
6.
Place the return desk on top of the connector plate.
Align as shown in Figure 7.
7.
Attach the return desk to the connecter plate using 5
#8 x 3/4" screws.
8.
Use 3 screws to install the bottom connector
plate between the desk and return as shown in
Figure 8: 2 #8 x 1/2" & 1 #8 x 1/4".
Note: The #8 x 1/4" screw is pre-installed to the
bottom connector plate. This screw will need to be
removed prior to installing the bottom connector
plate. Then after the bottom connector plate is
aligned this screw can be re-installed.
9.
Adjust leveling glides as needed to level desk front to
back and side to side.
Figure 7
Figure 8
#8 x 1/2" screws
20085
Publicidad
