Memory: Reviewing Readings; Stopping A Measurement - HEB inControl Premium BP3NQ1 4BHEB Manual Del Usuario

5.7. Memory: reviewing readings

At the end of a measurement, this monitor automatically stores
each result with date and time. This unit stores 99 memories for
each of 2 users.
Viewing the stored values
With the unit off, press the "M" button. The display first shows
"A", then shows an average of all measurements stored in the
unit. Please note: Measurements for each user are averaged
and stored separately. Be certain that you are viewing the
measurements for the correct user.
Pressing the "M" button again displays the previous value. To
view a particular stored memory, press and hold the "M" button
to scroll to that stored reading.
Memory full
When the memory has stored 99 results for the selected user, a
new measured value is stored by overwriting the oldest value.
Clear all values
If you are sure that you want to permanently remove all stored
values, hold down the "M" button (the instrument must have
been switched off beforehand) until "CL" appears and then
release the button. If you do not want to clear the values, press
the START/STOP button. To permanently clear the memory,
press the "M" button while "CL" is flashing.
1
Individual values cannot be cleared.

5.8. Stopping a measurement

If it is necessary to interrupt a blood pressure measurement for
any reason (e.g the patient feels unwell), the power button can
be pressed at any time. The device then immediately lowers the
cuff pressure automatically.
22