Whirlpool WGD8500DR Instrucciones Para La Conexión

Inlet Hose Connection Instructions for Steam Dryers
Instrucciones para la conexión de la manguera
Instructions de raccordement du tuyau d'arrivée
d'eau pour les sécheuses avec vapeur
TOOLS AND PARTS
Gather the required tools and parts before starting installation. The dryer must be
connected to the cold water faucet using the new inlet hoses. Do not use old hoses.
Tools needed: Parts Supplied:
Pliers "Y" connector
2' (0.6 m) Inlet hose
1. Turn cold water faucet off and remove washer inlet hose.
2. Remove old rubber washer from inlet hose and replace
with new rubber washer provided. Inspect hoses to be sure
rubber washers are in place.
3. Attach 2' (0.6 m) inlet hose to cold water faucet. Screw on
coupling by hand until it is seated on faucet.
4. Using pliers, tighten the couplings with an additional
two-thirds turn.
NOTE: Do not overtighten. Damage to the coupling can result.
5. Attach "Y" connector to the end of small hose. Screw on
coupling by hand until it is seated on connector.
6. Attach dryer 5 ft (1.5 m) inlet hose ends to the "Y" connector.
Attach washer cold inlet hose to other side of "Y" connector.
Screw on coupling by hand until it is seated on connector.
Using pliers, tighten the couplings an additional two-thirds turn.
NOTE: Do not overtighten. Damage to the coupling can result.
W10701405A
de entrada para secadoras con vapor
INSTALLATION REQUIREMENTS
Rubber washer
CONNECT INLET HOSES
Parts needed:
(Not supplied with dryer)
5' (1.5 m) Inlet Hose
7. Using pliers, tighten the couplings an additional two-thirds turn.
NOTE: Do not overtighten. Damage to the coupling can result.
8. Attach other end of 5' (1.5 m) inlet hose to fill valve at bottom
or top of dryer back panel (depending on model). Screw on
coupling by hand until it is seated on fill valve connector.
9. Using pliers, tighten the couplings an additional two-thirds turn.
NOTE: Do not overtighten. Damage to the coupling can result.
10. Check that the water faucets are on.
11. Check for leaks around "Y" connector, faucet, and hoses.
Your installation may require
additional parts. To order,
please contact the dealer
from whom you purchased
your dryer or an authorized
service company.