Luminance Brands Kathy Ireland Home CARRERA CF784BS03 El Manual Del Propietario página 6

3. Ceiling Fan Assembly
3.4
NOTE: Take care not to scratch fan housing when
installing blades.
Loosely attach One Blade/Flange Assembly to the
Motor Hub by securing the Two 1/4-20 x 14mm Pan
Head Screws with Lockwashers . Make sure the Screws
are NOT tightened (Figure 4) .
Repeat this procedure for other Four Blade Assemblies .
WARNING
!
To reduce the risk of personal injury, do not bend
the blade flange when installing the blade flanges,
balancing the blades or cleaning the fan. Do not insert
foreign objects in between rotating fan blades.
A spare 1/4-20 x 14mm Pan Head Screw with
Lockwasher is supplied in the loose parts bag,
if required .
3.5
NOTE: Each blade/flange assembly must have
the flange gasket in place between each of the
assemblies.
The Flanges have an Interlocking Feature that must be
Fully Engaged before Tightening the Screws .
Make sure all the Flanges are properly engaged and
then tighten the Flange Screws (Figure 5) .
If one of the Flanges does not seat properly on the
Motor Hub, loosen the adjacent Flange Screws,
re-engage and reseat the Flanges, then tighten the
Screws again .
(Continued)
MOTOR HUB
MOTOR HUB
NOTCHED AREA
1/4-20 x 14mm PAN HEAD
1/4-20 x 14mm CAPTIVE
PAN HEAD SCREW
SCREW WITH LOCKWASHER
(2 per blade/flange assembly)
(2 per blade/flange assembly)
Figure 4
FLANGE
INTERLOCKING
FEATURE
Figure 5
6
BLADE/FLANGE
ASSEMBLY
BLADE/FLANGE
ASSEMBLY
FLANGE
INTERLOCKING
FEATURE
U.L. Model No.: CF784-3