Installation
Preparation
Remove and recycle packing materials. Do not discard the
package containing two screws provided for installation.
If the cup warming drawer is installed independently, install
an anti-tip block against the rear cabinet wall. Verify the
screws are adequately secured and do not penetrate elec-
trical wiring or plumbing.
Installation
1
Turn off power to the electrical outlet.
Slide the left corner of the cup warming drawer into
2
the opening. If the electrical supply is located in the
opening, plug the power cord into the receptacle. If it
is located in an adjacent cabinet, guide the power cord
through the hole in the cabinet wall. Coil the excess
power cord behind or beside the unit.
3
Slide the unit back into the opening until the trim
meets the cabinet front. Avoid pinching the power cord
between the unit and cabinet wall.
4
Open the cup warming drawer to full extension. Drill a
pilot hole in each mounting hole, located at the front,
on each side of the unit. Refer to the illustration below.
5
Mount the unit using the two screws provided.
Turn power back on to the electrical outlet.
6
MOUNTING
HOLE
Mounting hole
Sub-Zero, Sub-Zero & Design, Sub-Zero & Snowflake Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, Wolf, Wolf &
Design, Wolf Gourmet, W & Design, red colored knobs, Cove, and Cove & Design are registered trademarks and service marks of Sub-Zero Group, Inc. and its subsidiaries.
All other trademarks are property of their respective owners in the United States and other countries.
Troubleshooting
IMPORTANT NOTE: If the warming drawer does not
operate properly, follow these troubleshooting steps:
•
Verify electrical power is supplied to the unit.
•
Verify proper electrical connections.
•
If the warming drawer does not operate properly, con-
tact Wolf Factory Certified Service. Do not attempt to
repair the appliance. Wolf is not responsible for service
required to correct a faulty installation.
wolfappliance.com | 7