Maintenance; General Maintenance - Ryobi TUFF SUCKER P710 Manual Del Operador

ADDING ATTACHMENTS
See Figures 5 - 7.
The brush attachment, crevice tool and squeegee attach-
ment can be easily snapped into place on your hand vac.
 Turn off the vacuum.
 Insert the attachment to the front end of the vacuum dust
bowl, making sure the attachment is firmly snapped into
place.
TO INSTALL
BRUSH
ATTACHMENT
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
WARNING:
Always wear safety goggles or safety glasses with side
shields during power product operation or when blowing
dust. If operation is dusty, also wear a dust mask.
WARNING:
To avoid serious personal injury, always remove the
battery pack from the product when cleaning or
performing any maintenance.
OPERATION
TO REMOVE

MAINTENANCE

Fig. 5

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
injury.
Only the parts shown on the parts list are intended to be
repaired or replaced by the customer. All other parts should
be replaced at an Authorized Service Center.
11
TO INSTALL
TO REMOVE
CREVICE TOOL
TO INSTALL
TO REMOVE
SQUEEGEE
ATTACHMENT
Fig. 6
Fig. 7