Before Using For The First Time - Westbend PCMC20RD13 Manual De Instrucciones

Please check all packaging material carefully before discarding. Accessory
parts may be contained within the packaging material. Wash popcorn tray,
popcorn scoop, and measuring cup and spoon in warm, soapy water. Rinse and dry
thoroughly. Use a soapy dishcloth to wipe the interior of the cabinet, then rinse with a
damp, non-soapy cloth and dry thoroughly. Wash the interior of the kettle with a
damp, soapy washcloth. Rinse and dry thoroughly. Do not immerse kettle in water
and do not get water on the black electrical box.
Assemble the Cart:
Cabinet
Support
Crossbeam (1X)
h-Shaped Side
Bracket (2X)
Cap Covers
1. Insert support crossbeam (small pegs on ends) and axle crossbeam (larger pegs
on ends) into one h-shaped side bracket. The axle crossbeam should sit so that
the fluted-side will face the floor when the cart is upright. Screw both crossbeams
into place. Repeat with other h-shaped side bracket.
2. Attach the wheels to the axle. Slide one wheel, silver rim side out, over an axle
hub. Use a washer with the screw and attach. Repeat with the other wheel.
Cover screws using included cap covers. Note: The wheels are attached to the
same side as the handle assembly.
3. Assemble the handle. Insert the prep shelf into the handle side, aligning the screw
holes. Screw into place. Insert the handle tube into the opening. Repeat with other
handle side.
4. Attach the cabinet to the base. Slide the cabinet onto the legs. Use the 4 wider
screws to screw all 4 corners inside the cabinet to attach to the legs.
5. Attach the handle assembly. Slide the assembled handle into the slots in the
cabinet. Press in until the tabs click in place. Screw the handles in from the top.
6. Place the popcorn popper on to the cart. The popcorn popper has suction cup
feet for added security. Your popcorn cart is now ready for use.
English - 3
B U
EFORE SING FOR THE
(2X)
F T
IRST IME
Prep Shelf (1X)
Handle Bar
Axle Crossbeam
Wheel
(2X)
Handle Side
(2X)
(1X)
(1X)