BGS technic 9784 Manual Del Usuario página 6

Use the jack on even ground only.
OPERATION
The owner and/or operator is responsible for providing maintenance, maintaining all decals or warning
labels and while in use, maintaining the unit in good work order. Read all warnings and instructions.
Make sure that the operator comprehends its contents. Safety information shall be emphasized and
understood prior to usage.
The jack shall be inspected per the instruction manual prior to use.
It is the owner and/or operators responsibility to study all WARNINGS, operating, and maintenance
instructions contained on the product label and instruction manual prior to operation of this unit, the
owner/operators shall retain product instructions for future reference.
RAISING VEHICLE:
1. Make sure the jack and vehicle are on a hand level surface.
2. Always set the vehicle parking brake and block the wheels
3. Consult the vehicle owners manual to ascertain the location of jack points and position the jack
beneath the prescribed lift point.
4. Turn the release valve clockwise to the closed position. DO NOT OVER TIGHTEN!
5. To raise the vehicle to designed height, place the handle into the socket and pump up and down.
6. Place jack stands beneath the vehicle at locations recommended by the vehicle manufacturer. Do
not get under the vehicle without jack stands. Jacks are not designed to maintain heavy loads for
long periods of time. Do not attempt to put jack stand simultaneously under both ends of vehicle
or under one side of vehicle.
7. Turn release valve SLOWLY counter-clockwise to lower load onto jack stands.
LOWERING VEHICLE:
1. Turn the release valve clockwise to the closed position.
2. Pump the handle to lift vehicle off of jack stands.
3. Remove the jack stands. Do not get under or let anyone else under the vehicle while lowering.
4. Turn the release valve SLOWLY counter-clockwise to lower the vehicle onto the ground.
INSPECTION
The product shall be maintained in accordance with the product instructions. No alterations shall be
made to this product.
1. Before each use, a visual inspection shall be made for abnormal conditions such as cracked welds,
damage, bent, worn, loose or missing parts.
2. Inspections shall be performed in accordance with this manual.
3. The product shall be inspected immediately if it is believed to have been subjected to abnormal
load or shock. Owners and / or operators should be aware that repair of this product may require
specialized equipment and knowledge.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed