Troubleshooting - BGS technic 9784 Manual Del Usuario

TROUBLE SHOOTING
PROBLEM
Jack will not lift to full height
Jack will not hold load
Lift arm will not lower
Jack feels spongy when lifting
Remove the retaining clip before use:
Press the yoke down and remove the retaining clip.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
POSSIBLE CAUSE
Low oil level
Release valve not closing
Hydraulic jack oil contaminated
Pump valves not sealing
Cylinder ram binding
Cylinder ram binding Parts worn
Internal damage
Broken return spring or
unhooked
Lift arm linkage bent or binding
See Air Purge section
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
ACTION
Check oil level
Call customer service
Call customer service
See Air Purge procedure
Press the yoke down
Retaining
Clip
Remove
retaining clip
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed