Acuity Brands JUNO 2JCTA150 Instrucciones De Instalación

JUNO 2JCTA150
Thick Ceiling Adapter
For use with Juno 2" LED Recessed when ceilings are 1" to 1 1/2" thick.
WARNING: For your safety, read and understand instructions
completely before starting installation.
SAVE THESE INSTRUCTIONS
INSTALLATION WITH
JUNO 2" LED RECESSED
Step 1. Remove both of the ceiling clamps,
screws, and plastic washers from the frame
assembly
(Figure 1). Replace the ceiling clamps with the
springs provided. Reuse the screws and washers
(Figure 2). Wire fixture following fixture instructions.
Step 2. Slide fixture thru ceiling opening and center
fixture in opening. Insure that alignment tabs are in
the hole (Figure 3).
Step 3. Insert adapter ring into ceiling opening and
hook the springs onto the ring edge (Figure 4).
Step 4. Tighten screws to secure adapter ring
against the ceiling (Figure 5).
DO NOT OVER TIGHTEN SCREWS.
Continue fixture installation per fixture instruction
sheet.
Alignment
Tabs
Figure 3
WARRANTY
5-year limited warranty. Complete warranty terms located at
www.acuitybrands.com/CustomerResources/Terms_and_conditions.aspx
Technical Services Phone (888) 387-2212
1300 S. Wolf Road • Des Plaines, IL 60018 • Phone 800-323-5068 • Visit us at www.acuitybrands.com/juno-recessed
©2017 Acuity Brands Lighting, Inc
INSTALLATION INSTRUCTIONS
Remove
Parts
Figure 4
Rev 5/17 P3729
Figure 1
Figure 5
Figure 2
Thick Ceiling
Adapter Spring
1 of 1