Assembly Instructions - Troy-Bilt TB360BV Manual Del Dueño/Operador

Aspiradora/ soplador de 2 ciclos a gasolina
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ASSEMBLING UNIT AS A BLOWER
Blower Tube Assembly
WARNING
:
To prevent serious personal injury,
stop the engine and allow the impeller to stop
before attaching or removing tubes.
WARNING
:
To prevent serious personal injury
or damage to the unit, the blower tube must be
installed while operating this unit as a blower.
WARNING
:
Never operate the unit in the blower
configuration without the vacuum door secured
and latched shut.
NOTE: If the unit was assembled as a vacuum unit, remove all
vacuum parts and store away in a secure place for
later use.
Installing
• Install the blower tube over the blower outlet and push it on
until both tabs snap into place (Fig. 1).
Removing
• Remove the blower tube by pressing both tabs at the same
time and pulling off the blower (Fig. 1).

ASSEMBLY INSTRUCTIONS

Tabs
Blower
Outlet
Fig. 1
ASSEMBLING UNIT AS A VACUUM
To assemble the unit as a vacuum, begin by removing the
blower tube. Refer to the previous section.
Vacuum Tube Assembly
WARNING
stop the engine and allow the impeller to stop
before attaching or removing tubes.
WARNING
damage to the unit, always install vacuum tubes and
the vacuum bag, and make sure the vacuum bag is
completely zipped closed when operating this unit
as a vacuum.
NOTE: If the unit was assembled as a blower unit, remove the
blower tube and store away in a secure place for later use.
Installation
1. Align the small arrow on the lower vacuum tube with the
arrow on the upper vacuum tube (Fig. 2).
Lower Vac Tube
2. Grasp the lower and upper vacuum tubes firmly with both
hands, and push the lower vacuum tube into the upper
vacuum tube. Turn the lower vacuum tube clockwise until it
snaps into place and locks. When properly assembled, the
dot on the lower tube aligns with the dot on the upper tube.
3. Flip the blower/vac so it is standing straight up on the
muffler cover. The front of the unit and the vacuum door
should face you.
4. Insert a flat head screwdriver under locking clip, lift upward
and open vacuum door (Fig. 3).
Locking
Clip
5
:
To prevent serious personal injury,
:
To prevent serious personal injury or
Arrows
Upper Vac Tube
Fig.2
Vacuum
Door Slot
Fig. 3

Publicidad

Tabla de contenido
loading

Tabla de contenido