Attach Flex Tube; Attach Operating Tube; Assembly - Troy-Bilt TB25BP Manual Del Operador

ATTACH FLEX TUBE

Put the hose clamp(C) on the flex tube before connect-
ing the flex tube and the fan's outlet tube together.
Connect the flex tube (B) to the fan's outlet tube (A) (Fig.
1) with a hose clamp (C) (Fig. 2) and tighten securely
(Fig. 2).
A
C

ATTACH OPERATING TUBE

NOTE: keep the throttle cable as straight as possible
when connecting the blower tubes.
1. Place the unit on flat surface during assembly. Insure
screw mechanism of clamp is positioned away from
operator.
2. Put the hose clamp (C) on the flex tube and the oper-
ating tube before connecting them together.
3. Turn the throttle linkage mark (D) so it aligns with the
throttle handle (F) (Fig.3). Insert the operating tube (E)
into the flex tube (B) (Fig. 3) and then tighten securely
with a hose clamp (G)(Fig. 4).
4. Attached throttle linkage clips (# 24-know your blow-
er) - to both ends of the flex tube to secure the throt-
tle cable. ( See Fig. 5 and Fig. 6)
ASSEMBLY INSTRUCTIONS
Fig. 1
Fig. 2
B
9
D
B
F
180˚
Fig. 3
G
Fig. 4
THROTTLE LINKAGE CLIPS
Fig. 5
THROTTLE LINKAGE CLIPS
Fig. 6
E