Yamaha CD-S3000 Manual De Instrucciones página 30

Ocultar thumbs Ver también para CD-S3000:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 152
Troubleshooting
Problem
The tuner is too close to this unit.
Noise from a nearby
tuner.
The disc may be warped.
Noise from inside of
the disc tray.
The output audio source setting on the connected
No sound from the
component is not "PCM."
component
connected to the
DIGITAL IN (OPTICAL
or COAXIAL) jack.
The batteries of the remote control are too weak.
The remote control
does not work.
Remote control is too far away or tilted too
much.
Direct sunlight or lighting (of an inverter type
fluorescent lamp etc.) is striking the remote
control sensor of this unit.
■ On USB connection
Problem
The operating system of the PC is not supported.
The connected PC
does not recognize
this unit.
Improper USB cable connection
The output of the PC or application is muted.
Another application is launched on the PC while
Noisy playback.
a music file is being played.
The music data are not properly reproduced,
Music files cannot be
because this unit is connected to the PC or the
played.
input of this unit is switched to "USB" while the
music application is running on the PC.
The dedicated "Yamaha Steinberg USB Driver"
has not been installed correctly.
30
En
Cause
Move the tuner and this unit farther apart.
Replace the disc.
Only PCM audio sources can be played via the
DIGITAL IN (OPTICAL/COAXIAL) jacks of
this unit.
Set the output audio source of the connected
component to "PCM."
Replace the batteries with new ones.
Use within 6 m and 60° radius.
Reposition this unit.
Cause
Use a PC with an operation-guaranteed operating
system.
Connect the USB cable properly.
Cancel the sound muting of the PC or
application.
If another application is launched while a music
file is being played, sound may be momentarily
lost or noise may be generated.
Do not launch other applications during
playback.
Connect this unit to the PC and set the input of
the unit to "USB" in advance. Then launch the
music application and start playback.
Install the "Yamaha Steinberg USB Driver"
again, following the correct procedure.
Remedy
Remedy
See
page
28
16
9
9
See
page
22
19, 22
23
22

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido