Installation and Assembly:
Adjustable Extension Column 6" - 12'
Models:
ALU006009 (-AB) (-AW)
ALU009012 (-AB) (-AW)
ALU012018 (-AB) (-AW)
ALU018024 (-AB) (-AW)
ALU0203 (-AB) (-AW)
ALU0305 (-AB) (-AW)
ALU0406 (-AB) (-AW)
ALU0507 (-AB) (-AW)
ALU0608 (-AB) (-AW)
ALU0810 (-AB) (-AW)
ALU1012 (-AB) (-AW)
NOTE: Read entire instruction sheet before you start installation and assembly.
• Do not begin to install your Peerless product until you have read and understood the instructions
and warnings contained in this Installation Sheet. If you have any questions regarding any of the
instructions or warnings, for US customers please call Peerless customer care at
1-800-865-2112, for all international customers, please contact your local distributor.
• This product should only be installed by someone of good mechanical aptitude, has experience
with basic building construction, and fully understands these instructions.
• Make sure that the supporting surface will safely support the combined load of the equipment and
all attached hardware and components.
• Never exceed the Maximum Load Capacity. See page one.
• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
• Tighten screws fi rmly, but do not overtighten. Overtightening can damage the items, greatly
reducing their holding power.
• This product is intended for indoor use only. Use of this product outdoors could lead to product
failure and personal injury.
• When installing or adjusting the ceiling mount, do not use adhesives, lubricants, or oils to prevent
the screws from loosening. If you use adhesives, lubricants, or oils to prevent the screws from
loosening, the casing may crack and the projector may fall, causing serious injury and damage to
the projector.
2300 White Oak Circle • Aurora, Il 60502 • (800) 865-2112 • Fax: (800) 359-6500 • www.peerlessmounts.com
WARNING
Max UL Load Capacity:
500 lbs (226.8 kg)
Note: The adjustable extension column
should only be used with Peerless UL Listed
products. The max load capacity for the
combined assembly is not to exceed the
lowest of all listed max load capacities.
ISSUED: 12-05-11 SHEET #: 154-9015-1