Connecting Electricity - GE PWS06D Serie Manual Del Propietario E Instrucciones De Instalación

IMPORTANT SAFETY INFORMATION
READ ALL INSTRUCTIONS BEFORE USING
WARNING
WARNING
This appliance contains isobutane refrigerant, also known as R600a, a natural gas with high
environmental compatibility. However, it is also combustible. Adhere to the warnings below to reduce
the risk of injury or property damage.
1. When handling, installing and operating the
appliance, care should be taken to avoid damage
to the refrigerant tubing.
2.
3.
the Federal and Local Regulations. The
flammable refrigerant and insulation material
used in this product require special disposal
procedures. Contact your local authorities for the
environmentally safe disposal of your appliance.

CONNECTING ELECTRICITY

WARNING
Plug into a grounded 3-prong outlet.
Do not, under any circumstances, cut or remove the third (ground) prong from the power cord.
For personal safety, this appliance must be properly grounded.
The power cord of this appliance is equipped with
a 3-prong (grounding) plug which mates with a
appliance.
Have the wall outlet and circuit checked by a qualified
electrician to make sure the outlet is properly
grounded.
If you have only a standard 2-prong wall outlet, it is
your personal responsibility and obligation to have it
replaced with a properly grounded 3-prong wall outlet.
NOTE: GFI (ground fault interrupter) is not
recommended.
The appliance should always be plugged into its own
individual electrical outlet which has a voltage rating
that matches the rating plate.
READ AND SAVE THESE INSTRUCTIONS
4
INSTALLATION
EXPLOSION HAZARD
FIRE OR EXPLOSION HAZARD Flammable Refrigerant
Electrical Shock Hazard.
4.
enclosures or in the built-in structure clear of
obstruction.
5. To remove frost, scrape with a plastic or wood
metal or sharp-edged instrument as it may puncture
the appliance liner and then the flammable
refrigerant tubing behind it.
6.
compartment of the appliance.
7.
appliance.
Failure to follow these instructions can result in
death, fire, or electrical shock.
This provides the best performance and also prevents
overloading house wiring circuits which could cause a
Never unplug your appliance by pulling on the power
cord. Always grip plug firmly and pull straight out from
the outlet.
Immediately discontinue use of a damaged supply
cord. If the supply cord is damaged, it must be
replaced by a qualified service professional with an
When moving the appliance away from the wall, be
careful not to roll over or damage the power cord.
49-1000514 Rev. 1