Inserting/Replacing Batteries (See Figure A); Starting Operation - Bosch PLL 1 P Manual Original

Line laser
Dimensions (length × width × height)
A) The working range may be reduced by unfavourable environmental conditions (e.g. direct sun-
light).
B) when the measuring tool is positioned correctly(see "Positioning the Measuring Tool (see fig-
ure B)", page 20).
C) Only non-conductive deposits occur, whereby occasional temporary conductivity caused by
condensation is expected.
The serial number (8) on the type plate is used to clearly identify your measuring tool.
Assembly
Inserting/Replacing Batteries (see figure A)
It is recommended that you use alkaline manganese batteries to operate the measuring
tool.
To open the battery compartment cover (10), push it away from the battery compart-
ment in the direction of the arrow. Insert the batteries.
When inserting the batteries, ensure that the polarity is correct according to the illustra-
tion on the inside of the battery compartment.
Always replace all the batteries at the same time. Only use batteries from the same man-
ufacturer and which have the same capacity.
Take the batteries out of the measuring tool when you are not using it for a pro-
u
longed period of time. The batteries can corrode and self-discharge during pro-
longed storage in the measuring tool.
Operation

Starting Operation

Protect the measuring tool from moisture and direct sunlight.
u
Do not expose the measuring tool to any extreme temperatures or variations in
u
temperature. For example, do not leave it in a car for extended periods of time. In
case of large variations in temperature, allow the measuring tool to adjust to the ambi-
ent temperature before putting it into operation. The precision of the measuring tool
may be compromised if exposed to extreme temperatures or variations in temperat-
ure.
Avoid substantial knocks to the measuring tool and avoid dropping it. Damaging
u
the measuring tool can cause accuracy to be compromised. If the laser line is subjec-
Bosch Power Tools
English | 19
PLL 1 P
154 × 24 × 30 mm
1 609 92A 56S | (26.08.2019)