Directions For Use - 3M PPS 2.0 Serie Manual Del Usuario

To reduce the risks associated with hazardous liquids:
• Read, understand, and follow all safety information contained in these instructions prior to using
the 3M™ PPS™ Series 2.0 Type H/O Pressure Cup. Failure to follow all instructions could result in
personal injury or product damage. Retain these instructions for future reference.
• Always refer to the safe use recommendations from the spray gun manufacturer, the Safety Data
Sheet and the label of the material being sprayed.
• Always wear appropriate Personal Protective Equipment including eye, respiratory, and skin
protection.
To reduce the risks associated with hazardous pressure:
• Before each use, inspect the pressure regulator, 3M™ PPS™ Series 2.0 Type H/O Pressure Cup,
Retaining Collar Shroud assembly and other pressure components for damage and ensure proper
function according to manufacturer's instructions.
• Be sure the supply pressure to the cup is controlled equal to or less than (≤) a maximum operating
pressure of 10 psi (69 kPa, 0.69 Bar).
• Do not allow paints, coatings or materials to dry or build up in the bottom of the cup. Hardened
materials may damage the built in pressure relief valve and/or result in loss of safety function.
• Never attempt to repair or block the built-in pressure relief valve at the base of the 3M™ PPS™
Series 2.0 Type H/O Pressure Cup; any such tampering of the cup may result in loss of safety function
and will void all warranties.
• Never attempt to block flow of air at the air cap of the spray gun while the unit is pressurized.
• Be sure to maintain spray gun equipment according to the manufacturer's instructions.
• Never allow the air cap to become obstructed with dried materials; periodically while spraying inspect
the spray gun air cap for buildup particularly when using highly viscous materials.
• Always follow the pressure relief / material bleed-back procedure for the pressure cup described in
steps 11 and 12 of the Directions For Use section of this manual.
• Always wear appropriate Personal Protective Equipment including eye, hearing and skin protection.
• Always refer to recommendations from the spray gun manufacturer and the Safety Data Sheet of the
material being sprayed.
• Always ensure the Shroud is engaged in the Retaining Collar prior to use.
• Always ensure that the Retaining Collar is properly seated and tightened prior to use.
• Always use 3M™ PPS™ Series 2.0 Lids and Liners for proper operation. Substitute products may
cause unexpected failure.
This product has been designed and manufactured in accordance with sound engineering practice. This
product has been evaluated per Article 4, Paragraph 3 of the Pressure Equipment Directive 2014/EU-Pressure
Equipment.
For the most up-to-date version of this manual, please visit your local 3M Collision website.

Directions for Use:

• Requires the use of a 3M™ PPS™ Series 2.0 spray gun adapter (sold separately) to attach the
3M™ PPS™ Series 2.0 Type H/O Pressure Cup to the spray gun. Reference Figure 1.
• Requires use of 3M Series 2.0 lids and liners , Mini 26114 / 26752, Midi 26112 / 26312, Standard
26000 /26026 , Large 26024 / 26740, to contain material to be sprayed.
• Requires an operating pressure of ≤ 10 psi (69 kPa, 0.69 Bar) to the 3M™ PPS™ Series 2.0
Type H/O Pressure Cup. The 3M™ PPS™ Series 2.0 Type H/O Pressure Cup contains a built in
WARNING
CAUTION
English - 2