Tabla de contenido
Publicidad
inStrUCtiOnS fOr 917 MODeL trACtOrS
Step 1: (fig. 1)
1. Open parts bags (A) and (B) to verify that all parts are
present.
Ref.
Part
A
43350
B
R19171616
C
44072
D
47674
PARTS BAG (B)
A
B
Step 2: (fig. 2)
1. Remove tractor hood. (Refer to tractor manual.)
2. If your tractor has a browning shield like the one shown,
remove it for easier assembly.
CAUTION! Muffler is hot! Allow engine to cool
down before removing browning shield.
REMOVE
FRONT SCREWS
REMOVE
BROWNING SHIELD
Qty. Description
4
Carriage Bolt, 3/8-16 x 1"
4
Washer, 1/2" x 1"
4
Whizlock Nut, 3/8"
4
Plug
PARTS BAG (A)
FIGURE 1
FIGURE 2
Step 3: (fig. 3)
1. Place plug on a work bench or solid table and push end of
bumper down onto plug (D). Repeat for all plugs.
PUSH DOWN
WITH EVEN
PRESSURE
WORK BENCH
OR SOLID TABLE
C
Step 4: (fig. 4)
1. Place washers (B) onto two carriage bolts (A).
2. Place the bumper over the front of the tractor frame
and insert the bolts through the rear holes in the tractor
frame and the slots in the bumper. Install whizlock nuts
(C) onto the bolts, but do not tighten yet.
D
CARRIAGE BOLT (A)
AND WASHER (B)
BUMPER
FIGURE 3
WHIZLOCK
NUT
(C)
FIGURE 4
ENglISh
PLUG
D
5
Publicidad
Tabla de contenido
