Publicidad
Idiomas disponibles
Idiomas disponibles
GB
The heating actuator is designed for controlling electro-thermal
servo-drives for heatings and air-conditioning ceilings.
The device has 6 electronic outputs permitting noise-free control of
electro-thermal servo-drives by means of EIB telegrams.
Up to 4 electro-thermal servo-drives (e.g. servo-drives from Heim-
eier, Sauter, Möhlenhof) can be connected to each output.
The outputs are controlled either by a switching or a PWM signal.
To prevent overloading of the device by strong inrush pulses, the
actuator switches its outputs with a time delay (0.5 seconds delay
from output to output).
Function
Characteristics
• Outputs suitable for resistive loads of I
• Overload/short circuit protection of the outputs ensured by
monitoring and shutoff of the corresponding channel with check-
back signal to the EIB.
• Output programmable as switching (1 bit) or as permanent (8 bit)
PWM signal.
• Emergency operation in the event of bus voltage failure
programmable for summer and winter.
• Protection against jamming valves programmable.
• Change of direction of the control action programmable.
• Read-out of current object values via the instabus.
• PWM manipulated variable approx. 50% on first commissioning.
• Forced-control position programmable
• Cyclic monitoring of the manipulated variables
GB
= 50 mA at 230 / 240 V.
N
Publicidad
