Service Mode - Bang & Olufsen 8660 Centro De Servicio Guía De Reparación

SERVICE MODE

MONITOR INFORMATION
- Software version numbers
The "20 IC5 DiSEqC SW 1.0" line is only shown if the TV is fi tted with satellite
receiver.
The "61 IC5 STB SW 1.0" line is only shown if the TV is fi tted with set-top box
controller.
The "61 IC5 STB TABLE 1.0" line shows the version of conversion of set-top box
remote control codes into Beo1 and Beo4 codes.
- Type, item and serial numbers
- Theft protection status. Shows if the Master code is correctly entered (STORED/
NOT STORED)
- Option programming
- Latest fi ve TV errors
- Latest ML error
- Latest AVL error from the V.TAPE and AV sockets
OPTION SETTING
Option 0 = The IR receiver of the TV is disconnected.
Option 1 = The TV and the Audio system (BeoLink system) are placed in the same
room.
Option 2 = The TV and Audio system (BeoLink system) are placed in different rooms.
Option 5 = The TV and Audio system (BeoLink system) are placed in the same link
room.
Option 6 = The TV is the only product in the link room.
Option programming can only be done by using a Beo4 remote control.
After having replaced the faulty chassis, please read out error codes, write them
down and let them follow the chassis going for repair. After that clear the error
codes. This is done by pressing GO in the MONITOR INFORMATION menu.
RESET TO DEFAULT
When this line is selected the settings will be defi ned.
- All TV and satellite programmes are cleared.
- The V.TAPE and AV sockets are set to NONE.
- In the PICTURE ADJUSTMENT service menu the values for brilliance, color and
contrast are set to default.
- All programme lists are cleared.
- The TV SETUP TUNE menu (if there is no satellite receiver) will be shown the fi rst
time the TV is switched on.
- OPTION is set to 1.
- The motor stand is set to centre position.
- The theft protection setup is not changed.
When RESET TO DEFAULT is selected a text "PLEASE WAIT" is displayed. While the
text is displayed no operation must be done. When the text disappears Service
Mode is exited.
Service mode, English 9.20