SNOWJOE 24V-SS13 Manual Del Operador página 12

Fig. 11
3. Remove the screws, the washers, and the bushings from
the drive wheel (Fig. 12).
Fig. 12
Bushing
4. Disassemble the right side cover by removing the five (5)
screws that hold it in place (Fig. 13).
Fig. 13
Right side cover
5. Use one hand to secure the auger, at the same time, use
the other hand to remove the auger assembly nut on the
right side. (Fig. 14).
Fig. 14
Belt
Auger
assembly nut
Drive wheel
6. From the left side, remove the auger axle set (Fig. 15).
Fig. 15
Washer Screw
7. Remove the old auger from the housing (Fig. 16).
Fig. 16
8. Install the replacement auger by following the above steps
12
in reverse order (Fig. 17).
Auger axle set
Auger