SNOWJOE 24V-SS13 Manual Del Operador página 9

Fig. 1
Push lock button
2. Check that the mains voltage is the same as that marked
on the rating plate of the battery charger. Then, plug the
charger adapter into an appropriate AC power outlet.
Connect the charger plug into the charge socket of the
battery to start charging (Fig. 2).
NOTE: If the plug does not fit the outlet or for connection
to a supply not in the U.S.A., use an attachment plug
adapter of the proper configuration for the power outlet.
Fig. 2
3. The battery will take approximately 5 hours to charge.
The battery indicator LEDs will twinkle and illuminate one
by one during the charging process. Unplug the charger
immediately when the 3 LEDs are all illuminated.
m
CAUTION!
FIRE HAZARD. When disconnecting the
charger from the battery, be sure to unplug the charger from
the outlet first, then disconnect the charger from the battery
m
WARNING!
This charger does not automatically turn off
when the battery is fully charged. Please take care not to leave
the battery plugged into the charger. Switch off or unplug the
charger at the mains when charging is complete.
4. Timely recharging of the battery will help prolong the
battery's life. You must recharge the battery pack when
you notice a drop in the equipment's power.
IMPORTANT! Never allow the battery pack to become
fully discharged as this will cause irreversible damage to
the battery.
Assembly
Connecting the Poles
1. Connect the upper pole assembly with the middle pole
assembly. Align the screw holes (Fig. 3).
Fig. 3
2. Insert a bolt through the aligned holes in the poles
Battery
and secure the other end with a knob (Fig. 4). Twist
indicators
until tight.
Fig. 4
Pole knob
3. Connect the upper pole + middle pole assembly with the
lower pole assembly. Align the screw holes (Fig. 5).
9
Upper pole
assembly
Middle pole
assembly
Bolt