OttLite G9700L Manual De Instrucciones

G
E
C
B
A
C
B
22w Ultimate Mag & Storage Station
G9700L
INS140128
F
D
J
H
G
F
E
D
A
ENGLISH
CONGRATULATIONS! You've purchased the finest in natural lighting
technology with your new OttLite
PRODUCT REGISTRATION FORM
Please complete the enclosed Product Registration Form and return it
today by mail, or register online by going to: OttLite.com/warranty.
NOTE: THIS UNIT IS FULLY ASSEMBLED
1. Remove all packing from lamp and place base (A) on a flat steady
surface.
2. Plug the cord into a standard household 120V AC outlet.
3. Turn the lamp ON or OFF by depressing pushbutton switch (E)
located in the front side of lamp body.
4. To reposition magnifier-lamp assembly housing (F), hold lamp
K
body with one hand and move position assembly as needed.
NOTE: It is suggested to grasp magnifier-lamp assembly housing
side-handle when repositioning assembly.
5. To use magnifier (G) located in the magnifier-lamp assembly
housing (F), open protective lid (H). Use protective cover (H)
when magnifier is not in use
6. Compartments (B, C) in body of lamp can rotate by hand.
7. Clips (D) hold a variety of objects securely in place so your hands
remain free.
BULB INSERTION/REMOVAL
1. Make sure that the lamp is not plugged into an electrical socket.
2. If the lamp has been in use, allow it to cool approximately
5 minutes before proceeding.
3. To remove the circline tube (K) already installed in the lamp,
remove clear bottom plastic cover (J), located in magnifier-lamp
assembly housing (F).
4. To remove clear plastic cover (J), twist and remove.
D
5. To remove circline tube (K), while holding socket with the other
hand, grasp tube firmly at the base and using a slight rocking
motion, pull it straight out of the socket.
6. To install a circline tube (K), hold firmly within the base, align
circline tube pins with mating pin-holes in socket then push it
straight into the socket until it "snaps" into place; place circline
K
tube onto hold clips inside magnifier-lamp assembly housing (F).
7. Proceed to install clear plastic cover (J), insert cover and twist to
secure.
Please note that in operation, OttLite
J
Enjoy your OttLite ® 22w Ultimate Mag & Storage Station!
PL7974
This lighting system is designed for use with
OttLite type
® product. ®
products voids the warranty and may result in
damage to the lighting system.
CAUTION!
UNATTENDED IN DIRECT SUNLIGHT OR WHERE LIGHT CAN SHINE THROUGH IT AS
THIS CAN POSE A RISK OF FIRE.
SAFETY WARNING:
MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
CAUTION! IMPORTANT SAFETY
INSTRUCTIONS:
THIS PORTABLE LAMP HAS A POLARIZED PLUG (ONE BLADE IS WIDER THAN THE
OTHER) AS A FEATURE TO REDUCE THE RISK OF ELECTRIC SHOCK. THIS PLUG WILL
FIT IN A POLARIZED OUTLET ONLY ONE WAY. IF THE PLUG DOES NOT FIT FULLY IN
THE OUTLET, REVERSE THE PLUG. IF IT STILL DOES NOT FIT, CONTACT A QUALIFIED
ELECTRICIAN. NEVER USE WITH AN EXTENSION CORD UNLESS PLUG CAN BE FULLY
INSERTED. DO NOT ALTER THE PLUG.
CAUTION!
THIS LUMINAIRE IS DAMAGED, IT SHALL BE EXCLUSIVELY REPLACED BY THE
MANUFACTURER OR ITS SERVICE AGENT OR A SIMILAR QUALIFIED PERSON IN
ORDER TO AVOID A HAZARD. INDOOR USE ONLY.
This product complies with Part 18 of FCC Rules, but may cause interfer-
ence to radios, televisions, wireless telephones, and remote controls. Avoid
placing this product near these devices. If interference occurs, move the
product away from the device or plug either into a different outlet. Do not
install this product near maritime safety equipment or other critical naviga-
tion or communication equipment operating between 0.45-30 MHz.
This Class B RFLD complies with Canadian ICES-005
® tubes are not dimmable.
22w Ultimate Mag & Storage Station
(Style Number CR22-L). Use of other
L
INDOOR USE ONLY. NEVER LEAVE THE MAGNIFIER LENS
TO PREVENT ELECTRIC SHOCK,
IF THE EXTERNAL FLEXIBLE CABLE OR CORD OF
REV080714