OttLite OTL13MAGWT03 Manual De Instrucciones

13w Classic Magnifier Task Lamp
OTL13MAGWT03
INS140127
English
CONGRATULATIONS!
You've purchased the finest in natural lighting technology with
your new OttLite product.
®
PRODUCT REGISTRATION FORM
Please complete the enclosed Product Registration Form and
return it today by mail, or register online by going to:
OttLite.com/warranty.
WARNING: To prevent electric shock, make sure the lamp is not
plugged in until all assembly steps are complete.
SWIVEL BASE ASSEMBLY
1. Snap part (J) onto the top of part (K) to form disk (L).
2. Insert the prongs of disk (L) into the circular metal hole in the
bottom of the lamp and snap into place (M).
3. The swivel base is now ready to use.
4. Plug lamp into a standard 120V socket. Your lamp is ready for
use.
TUBE INSERTION/REPLACEMENT
1. Make sure the lamp is not plugged into an electrical socket.
2. If the lamp has been in use, allow it to cool approximately five
minutes before proceeding.
3. Remove shade (A) and magnifier (B) by pulling away from
lamp using a slight side to side rocking motion, as indicated in
diagram (C).
4. To install a tube in the socket, hold the tube firmly by the base
and push it straight into the socket until it "snaps" into place
(F).
5. To remove a tube already installed in the lamp, grasp it firmly in
your hand and pull it straight out of the socket (E). Do not twist
or turn the tube.
6. Replace the shade by pushing it back into the body of the lamp.
Slide on the magnifier (B) at the front end of the shade, as
shown in diagram (G).
7. To tighten or lotosen the tension in the shade pivot point, use a
coin in the slot on the side of the lamp.
8. To open the magnifier case for use, apply gentle pressure to
the tab in the side of the case and pull the lid upward. The
magnifier will then be exposed and you can flip down for use.
9. Plug the lamp into a standard 120V socket. Your lamp is ready
for use.
CAUTION
Risk of fire! Never place the Magnifier Attachment under
direct sunlight.
Please note that in operation, OttLite
dimmable.
GX7902
13w Classic Magnifier Task Lamp
Enjoy your OttLite
This lighting system is designed for use with OttLite
type (style number PL13-E). Use of other products
voids the warranty and may result in damage to the
lighting system.
CAUTION!
this luminaire is damaged, it shall be exclusively replaced by the
manufacturer or its service agent or a similar qualified person in
order to avoid a hazard. Indoor use only.
CAUTION!
plug to wide slot, fully insert.
CAUTION! ImpOrTANT
sAfeTy INsTrUCTIONs:
This portable lamp has a polarized plug (one blade is wider than the
other) as a feature to reduce the risk of electric shock. This plug will
fit in a polarized outlet only one way. If the plug does not fit fully in
the outlet, reverse the plug. If it still does not fit, contact a qualified
electrician. Never use with an extension cord unless plug can be fully
inserted. Do not alter the plug.
This product complies with Part 18 of FCC Rules, but may cause
interference to radios, televisions, wireless telephones, and
remote controls. Avoid placing this product near these devices. If
interference occurs, move the product away from the device or plug
either into a different outlet. Do not install this product near maritime
safety equipment or other critical navigation or communication
equipment operating between 0.45-30 MHz.
This Class B RFLD complies with Canadian ICES-005
tubes are not
®
® Classic Magnifier Task Lamp!
®
If the external flexible cable or cord of
To prevent electric shock, match wide blade of
REV070214