Before Initial Use; Ice Cube Production - essentiel b EMG3 Instrucciones De Uso

before initial use

IMPORTANT: Before plugging the appliance into
the mains for the first time, let the appliance stand
with the lid open on a flat and stable surface for at
least 2 hours to allow the refrigerant gas to flow
back into the compressor.
Failure to do so could damage the compressor.
1. Take the appliance out and remove all of the packaging.
2. Before using the appliance for the first time (or after a period of disuse), clean
the water tank and ice basket. Use the first ice production cycle to rinse the
system. Discard the water and ice cubes produced in the first cycle.
3. The appliance must be placed in a well-ventilated environment where the
temperature is above 5°C, away from heat sources (ovens, heaters, etc.).
4. Leave a clearance of 20 cm on both sides of the appliance.
5. Make sure that the drain plug is properly in place.
use
This ice maker is different than traditional commercial ice makers. Its portable
design makes it ideal for at home use.
On/Off: Press the button
•
also used to restart a cycle.
Selecting ice cube size: press the button
•
An indicator light shows red to indicate the selected size:
- large ice cubes or
- small ice cubes .
The selected mode remains in place unless you change it or a power failure
occurs.
18
to switch the appliance on/off. This button is
to select the ice cube size.
Water level indicator light: the indicator light
•
level in the tank is low.
Full ice cube tray indicator light: the indicator light
•
ice in the ice basket has reached full capacity.
Cleaning required indicator light: the indicator light
•
appliance requires cleaning.

Ice cube production

1. Plug the appliance into a mains socket. The indicator light
flashing. If the ice maker has been moved, wait 30 minutes before plugging
it into the mains.
2. Open the lid and remove the ice basket.
3. Fill the water tank with room temperature drinking water (max. 2.8 L). Keep
the water level below the MAX mark.
4. Put the ice basket back and close the lid.
5. Select the desired ice cube size by pressing the button
Comment:
- Select the "small ice cube" size when the room temperature is below
15°C.
- The "large ice cube" size is recommended when the room temperature
exceeds 30°C.
6. Press the button . Ice cube production begins and the indicator light
remains solid.
Note: during the first 3 cycles, the ice cubes may be small and irregular.
7. The indicator light comes on when the ice basket is full. The appliance
automatically stops producing ice.
8. Open the lid and use the ice scoop to move the ice cubes to a freezer. Ice
cubes can be stored in the appliance for up to 18 hours, depending on the
room temperature.
9. Within 5 seconds of ice removal, the appliance will automatically restart
a cycle.
comes on when the water
comes on when the
comes on when the
starts
.
19