Stahlwille MULTIPOWER MP300–800 Instrucciones De Utilizacion página 5

How to replace the overload cutout on MP300–1350
Tools required:
Circlip pliers for inside circlips size J 4 or J 41 for
circlips from 85–165 mm – e.g. STAHLWILLE No 6543
or No 6544
Procedure:
– Remove circlip
– remove lid
– extract all the components making up the faulty
rated breakpoint (sun wheel) and replace with spares
– reposition cover and refit circlip.
How to replace the overload cutout on MP300–2000,
MP300–3000, MP300–5000
Tools required:
Offset screwdriver size 3 – e.g. STAHLWILLE
No 10760CV or INHEX insert size 3 – e.g. STAHLWILLE
No 44 with appropriate base tool
Procedure:
– Unscrew and remove the 6 Allen-head screws in the
upper cover
– remove the cover
– extract all the components making up the faulty
rated breakpoint (sun wheel) and replace with spares
– reposition cover and tighten screws by hand.
MULTIPOWER torque multipliers – technical specifications at a glance
No
Max. output N m
ft.lb
Max. input N m
ft.lb
Gear ratio
Torque ratio
a
D
Overload safety
Recommended torque wrenches
Recommended sockets
Width mm
Height mm
Length mm
R
g with box
MP300–800 MP300–1350 MP300–2000 MP300–3000 MP300–5000
800 1350
590 996
229 375
169 277
4:1 4:1
1:3.5 1:3.6
1 / " 3 / "
2 4
3 / " 3 / "
4 4
v v
No 721/30 No 730N/40
No 735/40
No 55, No 56 No 55, No 56
No 55IMP No 55IMP
No 56IMP No 56IMP
66 90
84 106
215 265
1500 3400
5400 6900
Overload cutout
(sun wheel)
Rated breakpoint
CAUTION!
– If the rated breakpoint should break, immediately
stop working with the MULTIPOWER to prevent
damage to the internal components in the gearbox.
– MULTIPOWER tools can only be calibrated as a
complete set. This means that not only the complete
MULTIPOWER case but also the torque wrench
which is used in conjunction with the MULTIPOWER
tool must also be returned for calibrating.
The MULTIPOWER tools alone cannot be correctly
calibrated.
2000 3000
1475 2212
160 240
118 177
16:1 16:1
1:12.5 1:12.5
1 / "
2
1"
v
No 721/30 No 730N/40
No 735/40
No 60 No 60
No 60lMP No 60lMP
No 66IMP No 66IMP
95
161
330
7000 7000
10500 10500
5000
3687
294
217
20:1
1:17
3 / " 3 / "
4 4
1" 1 1 / "
2
v v
No 730N/40
No 735/40
No 867IMP
No 60lMP
No 867IMP
No 66IMP
95 120
161 180
330 400
10400
13800
5