Publicidad
Idiomas disponibles
Idiomas disponibles
Preparation Before Spraying Foam
Set-up Procedures for Single Package Disposable Spray Foam Kits
Push in top of front panel to
open. Pull down flap for
dispensing unit hose assembly.
Remove nozzle packet and
read instructions.
Set-up Procedures for Dual Package Disposable Spray Foam Kits
Invert each cylinder several
times before use to insure
proper mixing.
To Attach Nozzle
Before attaching nozzle, use
petroleum jelly on face of
gun. After attaching nozzle,
spray into "test shot" recep-
tacle. Unit is ready to use.
WARNINGS:
Follow safety precautions and wear protective equipment as recommended. Consult Material Safety Data Sheet (MSDS) for specific information. Use in
a well ventilated area with certified respiratory equipment. NIOSH approved positive pressure supplied air respirator or a negative pressure half mask with organic vapor
cartridge and dust/mist prefilters are recommended if exposure guidelines may be exceeded. Contents are very sticky and may be irritating to skin and eyes; therefore, wear
nitrile gloves, safety glass or goggles and clothing that protects against dermal exposure. If liquid chemical comes in contact with skin, first wipe thoroughly with dry cloth,
then rinse affected area with water. Wash with soap and water afterwards, and apply hand lotion if desired. If liquid comes in contact with eyes, immediately flush with
large volume of clean water for at least 15 minutes and get medical help at once. If liquid chemical is swallowed, do NOT induce vomiting and obtain immediate medical
attention. KEEP OUT OF REACH OF CHILDREN. For professional use only.
Extend attached dispensing unit hose assem-
bly.
Thread red coded hose to A-component
tank and black coded hose to B-compo-
nent tank and tighten with a 9/16" wrench.
Insert bottom tab of nozzle
into bottom slot of dispensing
unit.
85°F (29°C)
75°F (24°C)
Open top flap of box
to ex pose cylinder valves.
Attach top latch by pushing
towards back of unit, until an
audible "snap" is heard.
By turning the valves COUNTER
CLOCKWISE open both valves
completely. Top flap may be
re moved or left in place during
use or storage.
By turning the valves COUNTER
CLOCKWISE open tank valves
completely. Tank valves must be
upright during use.
To remove used nozzle, push
top latch up and forward to
unsnap.
Publicidad
