SelectBlinds ROMAN SHADES Guia De Instalacion página 3

PROGRAMMING AND USING YOUR REMOTE
4.
MOTORIZED ROMAN SHADES
WARNING: DO NOT attempt to raise or lower your motorized shade with
your hands. This may cause permanent damage to the motor, and other
components in the headrail, which may not be covered under your warranty.
Your shade's motor and remote(s) are pre-programmed at the factory,
and are ready to use once the shade is installed. Look for the tag with two
numbers on the back of each bottom rail. This indicates which channel and
remote your shade is programmed to.
All you have to do is install the battery in the remote. Open the battery
compartment at the bottom of the remote and insert the lithium battery into
the round slot, positive side up. Slide the battery cover back onto the remote.
HOW TO USE THE REMOTE
Press and hold the Down button to lower the shade. You can release when the shade begins
lowering.
Press and hold the Up button to raise the shade. You can release when the shade begins raising.
Press the Stop button to halt the up or down movement. If you later choose to program a favorite
position, holding the Stop button will automatically lift or lower the shade to this position.
Choose a channel by pressing the Channel Increase and Channel Decrease buttons. The Channel
Display at the top of the remote will illuminate the channel you are currently on.
To operate all your shades at the same time, set the remote to Channel 5, and then press the
Channel Increase button. This will illuminate all the Channel Display lights, which activates motors
on all channels.
PAIRING THE REMOTE WITH A MOTOR
NOTE: The factory pairs each of your shades to the remote. The following steps are only necessary if you want to change how the channels are
configured, or if you are adding a new shade to a remote already in use.
1. Disconnect the motor cable from the battery.
2. Set the remote to whichever channel you want to
program the shade to.
3. Both parts of this step must be completed within
three seconds. If you don't succeed, repeat this
step a bit faster, or have someone assist you.
A. Plug the motor cable back into the battery.
B. With your finger, quickly press and hold the
Confirm (C) button on the back of the remote.
When the shade jogs (a quick up and down movement), the remote is paired to the channel you've chosen.
®
Simple. Smart. Custom.
STEP 1
INSTALLATION GUIDE | ROMAN SHADES
REMOTE 01
REMOTE
BACKSIDE
LIMIT (L)
BY BF
CONFIRM (C)
C
S
Channel Display
Channel Display
Stop
Down
Down
Channel Decrease
Channel Decrease
Channel Increase
Channel Increase
STEP 3A
REMOTE
LABEL
LITHIUM
BATTERY
L
T BATTERY COVER
FRONT
FRONT
1 2 3 4 5
Up
Up
Stop
STEP 3B
CONFIRM (C)
BY BF
C L
S T
UPDATED MAY 2021 3