Roman Shades - SelectBlinds ROMAN SHADES Guia De Instalacion

INSTALLATION GUIDE

ROMAN SHADES

LIFT SYSTEMS: CORDED LIFT | CORDLESS LIFT
The difficulty level of this installation is ranked at Level 1. A piece of cake!
If you have questions or get stuck, call our Customer Care Team at 888-257-1840, or email customercare@selectblinds.com
HARDWARE AND PARTS INCLUDED
BRACKET WITH WINGNUT
CORDLESS HANDLE
*Recommended if mounting into hollow drywall.
MOUNTING THE BRACKETS
1.
NOTE: Corded and cordless shades have pre-drilled holes in the top of the headrail.
You will use these holes as a guide for your bracket placement.
INSIDE MOUNT
1. Grasp the shade by the headrail and hold it up inside the top of the window. Set it back
until the front of the shade is flush with the wall. Hold the shade in place, and with a pencil,
make a mark through each hole in the headrail. Set the shade aside.
2. Take a bracket and center the drop-bolt over each mark. Use the holes in the top of the
bracket to mark where your two screws will go.
3. Pre-drill the screw holes for each bracket with a 5/64" drill bit.* Align the brackets with
the holes, and use a Phillips drill bit to securely fasten the screws.
OUTSIDE MOUNT
1. Center and hold the headrail at least two inches above the window. While
keeping the shade level, make a small line with your pencil just above each of
the pre-drilled holes in the headrail. Set the shade aside.
2. Align the top edge of a bracket along each mark, and use the holes in the
back of the bracket to mark where your two screws will go.
3. Pre-drill the screw holes for each bracket with a 5/64" drill bit.* Align the
brackets with the holes, and use a Phillips drill bit to fasten the screws in place.
*If you are using wall anchors, pre-drill with a 1/4" bit instead, and tap the wall
anchors into the holes with a hammer before drilling in the screws.
®
Simple. Smart. Custom.
SCREWS WALL ANCHORS*
CORD CLEAT AND SCREW
INSTALLATION GUIDE | ROMAN SHADES
TOOLS REQUIRED
PENCIL TAPE MEASURE
5/64" DRILL BIT PHILLIPS SCREWDRIVER
PHILLIPS DRILL BIT
TOP OF HEADRAIL
PRE-DRILLED HOLES
PRE-DRILLED HOLES
BACK
Simple. Smart. Custom.
POWER DRILL
LEVEL
STEP LADDER
FRONT
DROP-BOLT
2" - 4"
UPDATED MAY 2021
®
5