Publicidad
Idiomas disponibles
Idiomas disponibles
Power Monitoring software:
Your UPS must be plugged to you computer by the com port (RS 232) to take advantage of all the features
of the monitoring software. This permit to the provided software a complete monitoring of the UPS : available
power, quality of the power, battery load, frequency.
Software Guide:
Put the CD rom into the appropriate drive. It runs automatically. If not, please click the start button and select run.
Type D:\\Windows\setup.exe the click ok.
On the next screen choose your operating system. Follow the on screen instruction to complete the installation.
Launch the software, and click help in the toolbar to obtain a complete software guide.
Battery Replacement Procedure:
The battery should be replaced within 30 to 90 days since the Power on indicator flashes (see status table above).
To verify that the battery must be replaced, proceed to a self-test. If the power-on led continue on flashing,
then, replace the battery following this procedure :
• Unplug the cable from the RS 232 plug and every equipments and then unplug the UPS from the AC outlet.
• Open the cover using the "PUSH" button on the back of the UPS.
• Remove the old battery, and replace by a new one.
• Replace the cover.
• Use the UPS as indicated in the Installation paragraph.
OUTPUT
UPS Capacity
Total Capacity (protection)
No. of sockets
Voltage (on battery)
Frequency (on battery)
Transfer time
INPUT
Voltage (single phase)
Frequency
PROTECTION
Unit Input
Overload Protection
Short circuit
Spike protection
BATTERY
Type
Typical Recharge Time
(90 % of charge)
Back-up time
(a PC with a 15" CRT screen)
Back-up time
(a PC with a 15" LCD screen)
Protection
PHYSICAL
Net weight Kg (lbs)
Dimension W x D x H (mm)
INTERFACE
Dry contact
RS 232
ALARM
Battery Back-up
Battery low
Charger abnormal
Overload
ENVIRONMENT
Ambient operation
Audible noise
• 300 VA
• 1200 VA
• UPS x 2, Bypass x 1
• Simulated sine wave at 220V, 230V, 240V +/- 5%
• 50 or 60 Hertz +/- 0.3 Hz
• 2/4 milliseconds, including detection time
• 220V +/- 25 %, 230V +/- 20 %, 240V +/- 20 % at line input
• 50 or 60 Hz +/- 10% (auto sensing)
• Circuit breaker or fuse for overload & short circuit protection
• AC mode: if loads exceed 110 % of nominal, buzzer continue beeping
sound.
Backup mode : UPS automatic shutdown if overloads exceeds 110 %
at 1 second.
• UPS output cut off immediately
• 480 Joules, 2 ms
• Sealed, maintenance free lead acid batteries, with 3-6 years typical
life time.
• 4 hours
• 4-6 minutes
• 8-12 minutes
• Over discharge protection, short circuit protection by fuse
• 1.9 (4.2)
• 100 x 315 x 68 (3.9 x 12.4 x 2.7)
• Sends low and power failure signals, and receives shutdown signal
from computer.
• Detect battery low, schedule UPS on/off, AC input/output power
status display
• Slow beeping every 4 seconds
• Rapid beeping every second
• AC mode : Rapid beeping sound every 0.5 second
• Continue beeping sound
• 3.500 meters max. Elevation, 0-95 % humidity non condensing, 0-40°C
• < 40 dBA (1 meter from surface)
ENGLISH
3
Publicidad
