Descargar Imprimir esta página

Lotus SmarTime 50010 Manual De Instrucciones página 9

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
I. Function of
watch.
0.1 Button description:
Side button: long press to turn on / off, short
press to return to the watch face interface.
Device can be hard reset by long pressing
for 10 seconds.
When inside a menu, swipe left to go to the
previous screen
0.2 Charging instructions:
This product charges using magnets for
support. Connect the charging points to the
charging pins on the back of the device as
shown, it will charge automatically. Supports
USB charging (5V). A full charge will take
around 70 minutes.
Note: Be careful not to short circuit between
the two charging points while charging, it can
lead to damage.
1.1 Watch Face in standby mode:
1) Swipe right to view the heart rate screen.
Wear the watch on your preferred wrist and
tap Start to measure your heart rate.
2) Swipe up or down to open the drop-down
menu to check Bluetooth status, battery life,
sound on / off, date and time.
3) Swipe left to open the main menu.
4) Press and hold the Watch Face while in
standby mode to change the watch face
type. Select by tapping OK.
1.2 Drop-down menu
Swipe up or down on the Watch Face inter-
face to open the drop-down menu.
1) The left icon shows the Bluetooth connec-
tion status. When the watch is connected to
a phone, the link icon in the upper part of the
screen will turn green.
2) The battery level is shown in the middle
part of the screen.
3) The right icon can be used to turn the
sound on and off.
1.3 Messages
Sync all the messages in the phone (not sup-
ported on iOS).
1.4 Phonebook
Sync all the contacts on the phone, max 400
contacts.
1.5 Call logs
Displays calls history.
1.6. Dialer
Tap the numbers to dial a phone number
to place a call. You can enable the device to
support Bluetooth call and music functions
by setting it as follows:
1.6.1. Find the name of the connected watch
in the More menu.
1.6.2. To connect, open your Phone's Set-
tings and enter the Bluetooth menu. Find
your watch below OTHER DEVICES and tap
it to connect.
1.6.3. To disconnect, open your Phone's Set-
tings and enter the Bluetooth menu. Tap the
"i" next to your watch and select Forget This
Device.
1.7 Exercise tracking (walking,
running, cycling, hiking, swimming,
football, basketball, table tennis,
badminton)
9

Publicidad

loading

Este manual también es adecuado para:

500115001250013