Attaching The Fan Blades - HAMPTON BAY Tropics Manual Del Propietário

6.
Finishing the Fan
Installation
WHEN USING THE STANDARD BALL/DOWN-
ROD MOUNTING, THE TAB IN THE RING AT
THE BOTTOM OF THE MOUNTING PLATE MUST
REST IN THE GROOVE OF THE HANGER BALL.
FAILURE TO PROPERLY SEAT THE TAB IN THE
GROOVE COULD CAUSE DAMAGE TO WIRING.
1. Align the four screw holes in the canopy
with the four screw holes in the mounting
plate.
2. Secure the canopy in place by using the four
mounting screws that were removed in step
1, described on page 4 (Figure 4).
Attaching the
Fan Blades
1. Attach blade to blade bracket, using the
blade bracket support plate, screws and
lockwashers provided (Figure 7). Start a
screw into the blade bracket. Repeat for the
remaining two screws.
2. Tighten each screw securely.
3. Remove the screw driver access cover on
the light kit plate to expose the blade bracket
screw holes (Figure 8a).
Figure 6
Screws and
Lockwashers
Support Plate
Blade Bracket
Screw Driver
Access Cover
Blade
Figure 7
Figure 8a