Hanging The Fan - HAMPTON BAY Tropics Manual Del Propietário

Hanging the Fan

REMEMBER
to turn off the power.
Follow the steps below to hang your
fan properly.
NOTE: This fan is recommended for the
standard ceiling mounting using the downrod
provided with this fan. When using standard
ceiling installation, the distance from the
ceiling to the bottom of the light kit will be
approximately 28 inches.
THE FAN MUST BE MOUNTED WITH A MINIMUM
OF 7 FEET CLEARANCE FROM THE TRAILING
EDGE OF THE BLADES TO THE FLOOR.
IF YOU FEEL THAT YOU DO NOT
HAVE ENOUGH ELECTRICAL WIRING
KNOWLEDGE OR EXPERIENCE, HAVE
YOUR FAN INSTALLED BY A LICENSED
ELECTRICIAN.
Standard Ceiling Mounting
1. Remove the mounting plate from the cano-
py by loosening the four screws on the top
of the canopy (Figure 4).
2. Route the wires exiting the top of the fan
motor through the decorative motor collar
cover and decorative downrod frame. Route
the wires through the canopy and then
through the ball/downrod assembly (Figure
5).
4.
Remove
3. Loosen, but do not remove, the set screws
on the collar on the top of the motor
housing.
4. Align the holes at the bottom of the downrod
with holes in the collar on top of the motor
housing (Figure 5). Carefully insert the bolt
through the holes in the collar and downrod.
Be careful not to jam the pin against the wir-
ing inside the downrod. Insert the clevis pin
through the hole near the end of the bolt un-
til it snaps into its locked position as noted
in the circle inset of Figure 5.
FAILURE TO PROPERLY INSTALL THE LOCKING
PIN AS NOTED IN STEP 4 COULD RESULT IN
FAN LOOSENING AND POSSIBLY FALLING.
5. Retighten the set screws on the collar on top
of the motor housing.
6. Make sure the decorative downrod frame
and motor collar cover properly seat on the
top of the fan motor assembly.
UL Listed
Outlet Box
Slide Mounting
Bracket Over
Screw Heads
Figure 4
120V Wires
Motor Wires
Ball/Downrod
Canopy
Decorative Motor
Collar Cover
Decorative
Downrod
Frame
Bolt
Tighten
Screws
7. Proceed to "Installing the Fan" section.
Mounting Screws
(supplied with
outlet box)
Hook
Ceiling
Mounting
Plate
Pin in locked
Position
Clevis
Pin
Motor
Collar
Figure 5