Taurus GALLERY 60 INOX Ver III Manual Del Usuario página 14

Make sure the filter is securely locked.
NOTE: When the carbon filter is connected, the
suction will be lower.
Modes
The device has 2 installation modes:
Recirculation mode and extraction mode.
Extraction mode:
The extraction mode expels the air to the
outside. This mode guarantees high
performance, high capacity and low noise level.
Recirculation mode:
The recirculation mode removes odours by
means of a carbon filter and reintroduces the air
into the kitchen. This mode is suitable for rooms
without extraction ducts, saves air and prevents
thermal losses to the outside.
For this mode, you need to obtain the carbon
filters and install them as explained in the
installation part, they are not included.
Instructions for use
Before use:
Remove the appliance's protective film.
Make sure that all products' packaging has been
removed.
Ensure that the selected tension on the voltage
selector coincides with the tension of the mains.
Use:
Connect the appliance to the mains.
Turn the appliance on, by using one of the speed
selection buttons (Fig.3).
Light function:
The appliance includes a light function, which
illuminates the working area under the appliance
(Fig.3).
Once you have finished using the appliance:
Stop the appliance by pressing the stop button
(Fig.3).
Safety thermal protector:
The appliance has a safety device, which
protects the appliance from overheating.
If the appliance turns itself off and does not
switch itself on again, disconnect it from the
mains supply, and wait for approximately 15
minutes before reconnecting. If the machine
does not start again seek authorised technical
assistance.
Practical tips:
It is recommended to keep the filters clean,
grease and dirt in the filters decreases the
efficiency of the engine and increases its energy
consumption.
Adjust the extraction speed according to the
amount of smoke, working at high speeds with
little smoke consumes more energy.
Cleaning
Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
Remove the filters, clean in hot, soapy water or
in a dishwasher. Replace parts correctly.
Cleaning is recommended every month.