HoMedics BKP-110-THP Manual De Instrucciones E Información De Garantía página 5

Please Note:
For your safety, this
product is equipped
with a pressure
activated switch
to control the heat
function. Heat will
not operate unless
pressure is applied
to this switch,
located on the seat
cushion of the unit
(see page 7). Once
pressure is removed,
heat will turn off. After
applying pressure,
please allow 5-10
minutes for heat
to reach maximum
temperature.
Note: There
is a 15-minute
auto shut off on
the unit for your
safety.
• NEVER use this product while in bed.
• This product should NEVER be used by any individual suffering from
any physical ailment that would limit the user's capacity to operate the
controls or who has sensory deficiencies.
• This unit should not be used by children without adult supervision.
• DO NOT use this product on any wooden surface as it may cause
damage.
• Attention California Residents:
WARNING: This product contains chemicals known to the
State of California to cause cancer, birth defects and other
reproductive harm.
Instructions for Use
For Use in Home or Office
1. Plug adapter into a 120 volt AC outlet and plug
the receptacle end into the input jack, located in the
bottom of the integrated control on the cushion.
2. Press the massage button on the control panel
once for low intensity massage (Fig. 1). Press it
again for high intensity massage.
3. To activate heat function, press the heat button
once (Fig. 1) . Press the heat button again to
deactivate the heat function.
Note: When selecting the heat feature, there will
be a slight decrease in the strength of the massage
output. This adjustment is perfectly normal and
should not be interpreted as a defect.
4. To turn the unit off, simply press the power
button once.
For Use in Your Car
1. Simply plug the 12 volt auto adapter into a 12V DC outlet and plug
the receptacle end into the input jack, located along the side of the cushion.
2. Slip the massage cushion straps over your seat.
3. Follow steps 2-4 above for operation.
4
Fig. 1