Connecting The Electrical Power To Magicspeed - Dometic GROUP WAECO MagicSpeed MSBE7 Instrucciones De Montaje Y De Uso

MagicSpeed MSBE7
➤ Remove the cover on the steering column.
➤ Drill a 10 mm hole.
➤ Insert the outer adaptor (fig. 6 2, page 5) onto the thread of the control lever
(fig. 6 1, page 5).
➤ Guide the thread through the drill hole.
➤ Attach the control lever by pushing the spring washers (fig. 6 4, page 5) and the inner
adaptor (fig. 6 3, page 5) onto the thread and tightening with the nut (fig. 6 5,
page 5).
➤ Lay the connection cable to the cable set.
➤ Replace the cover on the steering column.
7

Connecting the electrical power to MagicSpeed

7.1 General notes on laying cables
NOTE
I
 As far as possible, use original ducts for laying the cables, or other suitable
options, such as panelling edges, ventilation grilles or dummy plugs. If no
openings are available, you must drill holes for the cables. Check beforehand
that there is sufficient space on the other side for the drill head to come out.
 Cables and connections that are not properly installed will cause malfunctions
or damage to components. Correct installation of cables and connections en-
sures lasting and trouble-free operation of the retrofitted components.
Therefore, please observe the following instructions:
 To prevent damage to the cables, when laying them, ensure that they are far enough
away from hot or moving vehicle components (exhaust pipes, drive shafts, light sys-
tems, fans, heater etc.).
 Wrap insulating tape around every connection on the cable (even inside the vehicle).
 When laying electric connections (fig. 3, page 3), ensure that
– They are not kinked or twisted
– They do not rub on edges
– They are not laid in sharp-edged ducts without protection
 Protect every hole you drill against water penetration, e.g. by using a cable with a seal-
ant and by spraying the cable and the the cable sleeve with sealant.
EN
Connecting the electrical power to MagicSpeed
23