Programming Magicspeed; Performing A Functional Test - Dometic GROUP WAECO MagicSpeed MSBE7 Instrucciones De Montaje Y De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 39

Programming MagicSpeed

7.2
Connecting the control lever
➤ Plug the connection cable of the control lever (fig. 7 1, page 5) as follows into the
sockets of the 8 pin plug housing (fig. 7 2, page 5):
– Blue into slot 1
– Brown into slot 2
– Yellow into slot 3
– Black into slot 4
– Slot 5 is not assigned
– Red into slot 6
– Green into slot 7
– Orange into slot 8
Make sure that the colours on the connection cables match those on the mating con-
nector or the colour markings on the plug housing.
➤ Lay the connection cable for the control lever to the electronic module.
➤ Plug the assembled 8-pin compact plug of the control lever into the 8-pin socket of the
cable set of the MagicSpeed cruise control (fig. 8, page 5).
8
Programming MagicSpeed
➤ Program MagicSpeed as described in the installation and operating manual of the
cruise control.
9

Performing a functional test

NOTE
I
The lowest speed at which the speed regulator can operate is approximately
30 km/h and the highest approximately 140 km/h
➤ Start the vehicle.
➤ Switch on the cruise control by pressing the control lever in the
✓ The LED on the control lever lights up green.
✓ You will hear two signals.
➤ Drive at a speed of approx. 40 to 50 km/h.
➤ Press the control lever in the
✓ The LED on the control lever lights up orange.
✓ The cruise control gently takes on the speed and maintains the driving speed
constantly.
24
direction to activate the cruise control.
MagicSpeed MSBE7
direction.
EN

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

9101400068

Tabla de contenido