Publicidad
Idiomas disponibles
Idiomas disponibles
Make sure your electricity supply is the same as the one shown on the underside of
the power unit.
Remove all packaging including the plastic blade covers from the knife blade. These
covers should be discarded as they are to protect the blade during manufacture and
transport only.
Wash the parts: see "cleaning".
o Place the non slip mat onto the work-surface, rib upside down.
o Position the bowl onto the middle of the non slip mat.
o Fit the knife blade over the pin in the bowl.
o Add your food, see processing guide.
o Fit the splashguard. Make sure the slots in the splashguard fit over the
The super chopper will not operate unless the splashguard in fitted in the right
position.
o Fit the power unit.
o The power unit will only fit correctly in two positions.
o Plug in. press down on the power unit for short lengths of time to produce a
o If the appliance is overloaded, remove some of the mixture and continue
o Stop the appliance and scrape down if necessary.
o Do not run the chopper continuously for longer than 10 seconds. Leave to
o After use. Unplug and dismantle.
Always switch off and unplug before cleaning.
Handle the cutting blade with care as they are extremely sharp.
Some food will discolor. It won‟t harm the plastic or affect the flavor of your food.
Before plugging in
Before using for the first time
To use the food chopper
Cut large pieced of food into 1-2 cm (1/2-3/4 in pieces).
Don‟t chop hard foods such as coffee beans, ice cubes, spices or
chocolate-you‟ll damage the blade.
handles in the rim of the bowl.
pulsing action-this will avoid over processing the ingredients.
processing in several batches.
cool for 1 minute in between each 10 seconds operation.
Cleaning
Publicidad
