Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
How
to Use Accessory
Tray
The unit is equipped with an accessory tray with places to
store your spray gun and nozzle extension.There
is also a
hook at the front of the accessory tray to hold your high
pressure hose.
NOTE:
The extra hole in the tray is for storing a utility
brush.The
extra clip in the tray is for storing a turbo
nozzle.The
brush and turbo nozzle are NOT
included with
your pressure washer.You can buy these items as optional
accessories.
I.
Place nozzle extension
through
hole on accessory
tray,
as shown
in Figure 13.
I
2.
Place spray gun through
hole on accessory
tray on
right side of unit (Figure
13).
3.
Hang high pressure
hose on hook attached
to
accessory
tray on front of tray, as shown
in Figure 13.
How
to Use SprayTips
The quick-connect
on the nozzle extension
allows you to
switch
between
four different
spray tips.The
spray tips vary
the spray pattern
as shown
(Figure
14).
CAUTION
. NEVER exchange spray tips without engaging the safety latch
on the spray gun trigger.
Follow
these
instructions
to change
spray tips:
I.
Engage trigger loci< on spray gun.
2.
Pull bad< collar on quick-connect
and pull current
spray tip off. Store spray tips in holder provided on the
nozzle extension.
3.
Select
desired
spray tip:
•
For gentle
rinse, select white 40 ° spray tip.
•
To scour surface,
select yellow
15° or red 0 ° spray
tip.
•
To apply chemical,
select black spray tip.
Low
Pressure
Black
Use to apply
chemical
High
Pressure
40 ° White
15 ° Yellow
0 ° Red
4.
Pull back on collar, insert new spray tip and release collar.
Tug on spray tip to make sure it is securely in place.
5.
For most effective cleaning, keep spray tip from 8 to
24 inches away from cleaning surface. If you get spray
tip too close, you may damage cleaning surface.
6.
DO NOT get closer
than 6 inches when
cleaning tires.
Cleaning
and Applying
Chemical
IMPORTANT:
Use soaps designed
specifically
for
pressure
washers.
Household
detergents could damage
the pump.
CAUTION
. Starting the engine without all the hoses connected
and
without the water turned ON will damage the pump.
. Damage to equipment resulting from failure to follow this
instruction will void warranty.
To apply
detergent
follow
these
steps:
I.
Review spray tip use.
Publicidad
Tabla de contenido
